2 Safety Recalls Found for Cars Like Yours
Recalls may not affect every vehicle of the same year, make and model. Use your VIN or plate to find out if your specific car has open recalls.
2000 Chevrolet Blazer Recalls
NHTSA CAMPAIGN ID:
99V220
Vehicles Affected:
3947
What You Should Do:
Dealers will inspect the brake pipe union for signs of brake fluid and, if necessary, install a new brake pipe union. Owner notification began during late August 1999. Owners who do not receive the free remedy within a reasonable time should contact Chevrolet at 1-800-222-1020.
Summary:
On certain pickup truck and sport utility vehicles equipped with 2-wheel drive, the right-hand antilock brake system (ABS) module feed pipe and/or brake crossover pipe tube nuts could have been tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. If this occurred, the seal could have been broken during vehicle assembly, or brake fluid cycling, and a leak could occur, increasing the brake stopping distance. If so, the vehicle would not comply with requirements of FMVSS No. 105, "Hydraulic and Electrical Brake Systems".
To see if your specific vehicle is affected
Tip: Recalls don’t affect every vehicle of the same year, make and model. You’ll need your car’s 17-digit Vehicle Identification Number (VIN) to know for sure.
NHTSA CAMPAIGN ID:
00V228003
Vehicles Affected:
156305
What You Should Do:
Dealers will inspect the vehicle's rear safety belt buckle assembly date codes and, if necessary, will replace any rear safety belt buckle assembly. The manufacturer has reported that owner notification was to begin during September 2000. Owners who do not receive the free remedy within a reasonable time should contact Buick at 1-800-521-7300; Chevrolet at 1-800-222-1020; GMC at 1-800-462-82, Oldsmobile at 1-800-442-6537; Pontiac at 1-800-762-2737; or Saturn at 1-800-553-6000.
Summary:
Certain passenger vehicles, light duty pickup trucks, sport utility vehicles, and mini vans equipped with TRW seat belt buckle assemblies fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 209, "Seat Belt Assemblies." The buckle base of these seat belt assemblies were not properly heat treated and do not pass the load bearing requirement of the standard. In the event of a vehicle crash, the occupant may not be properly restrained.
To see if your specific vehicle is affected
Tip: Recalls don’t affect every vehicle of the same year, make and model. You’ll need your car’s 17-digit Vehicle Identification Number (VIN) to know for sure.
Recall information provided by the National Highway Traffic Safety Administration